Easy Assembly
Maxfun electric scooter are shipped 95% assembled.
It takes a few easy steps to complete the assembly and around 15 minutes to complete.
Unfolding

- The first step is to unfold your electric scooter. To do this, make sure the hooks are not caught on the rear foot – board. If it is, push the rod down and remove it from the rear footboard.
- Unfold the steering bar by pulling it to a vertical position. Ensure you do so until the Steering Bar is completely verti – cal.
- Make sure the steering bar is secured by turning the safety lock to the right until it is tight.
- Lastly, make sure the safety button of the folding mechanism is clipped to the steering bar. This safety mechanism prevents the latch from unlocking due to vibration or shock.
Install handlebars

- The first step is to remove 4 screws in order to install the handlebar of the electric scooter.
- Put on the handle of the electric scooter, then align the mounting module with the four screw holes, and press the module.
- Press and hold the installation module, and screw the four screw holes to the right respectively, don’t tighten it, just hang it.
- Finally, tighten the screws on the four screw holes to the right to ensure that the handle is installed securely.